How to flash N7000ZSKK1 (2.3.6)

Download these files:

1. Download N7000ZSKK1
2. Download ODIN

Now you are ready to flash.

TODO
1. Run ODIN on your PC

Note: Make sure your phone is 100% for better battery calibration

2. Odin Configuration (See image above for files setup)
- Check Re-Partition, Auto Reboot, and F. Reset Time options.

- Check and select .pit file
Q1_20110914_16GB.pit
- Check and select PDA file
CODE_N7000ZSKK1_CL706440_REV02_user_low_ship.tar.md5
- Check and select PHONE file
MODEM_N7000XXKJ6_REV_05_CL1070146.tar.md5
- Check and select CSC file
GT-N7000-MULTI-CSC-OZSKK1.tar.md5

Note: Bootloader. Leave it BLANK

3. Ready your phone in Download Mode by pressing  
Volume down + Home + Power on Button, then press Volume Up to continue.

4. Connect your PC and Phone via USB cable provided until COM port connected.
5. Once ready, click Start button

6. Sit back and relax and let's it finished. Green and PASS
7. Disconnect phone. DONE

Optional: 
Do the reset by pressing *2767*3855# from dial pad. Extremely dangerous. It will WIPE your phone after pressing #. Do BACK-UP!

You should have this at the end of flashing...

Important: After reboot remember to Change Language to English on the first screen. By default it's Chinese.

For your knowledge:

• PDA is the operating system with its programs and settings included.
• PHONE is the modem firmware file, parts of which are required to access the hardware.
• CSC (for consumer software customisation) are the regional settings applied which may install additional programs as well as provider-specific settings (APN